5/2/2024 0 Comments Handicap railing requirementsSlide the opposite end of the handrail return onto the internal connector until it's touching the metal spacer screw. The wall return is designed to fit tightly into the rail, so the location of the attachment is critical. Make sure the wall return is at the proper angle of alignment to the post. Next, attach the wall return to the lower end of the handrail return (the longer side). Once everything is lined up, slide the internal connector into the appropriate elbow until the metal spacer screw is touching either end of the elbow or the collar, if you used one. This means checking that the wall mount on the post lines up with the location of the elbow on the rail. Step 2: Align the componentsīefore you attach anything, make sure all the components are aligned properly. Slide the collar ring over the rail before inserting it into the other component. You'll also want to use a collar ring if you want to hide the seam between the handrail return and the rail or elbow. Step 1: Cut the railingįirst, make sure you have the right railing length for your handrail return. Handrails ensure your railing extends beyond the top and bottom of a set of stairs or a ramp, as required by ADA guidelines. Step 5: Attach the railįinally, attach the connected rail to the wall mount using the provided hardware and finish by attaching the end cap to the rail for a safe, professional finish. To help with an angled attachment, place one screw into the bottom hole of the bracket and pivot the wall mount to the required position. Make sure each wall mount is at the proper angle of alignment to the angle of the rail. Step 4: Attach wall mountsĪttach wall mounts as needed to posts using the provided hardware, keeping in mind that a wall mount must be used at each rail-to-rail seam connection. With the screw removed, push the second rail further over the internal connector until it fits in the collar or tightly against the opposite rail. Next, remove the spacer screw using a #2 square-head screwdriver. Next, slide the second rail over the opposite end of the internal connector until it is also touching the metal spacer screw. Slide the internal connector into the rail end until the metal spacer screw touches either the end of the handrail or the collar if you’re using one. Make sure to slide the collar over one rail before connecting. To hide the seam where the two pieces of handrail will meet, you can use a collar ring. Step 1: Cut the railingĬut railings to size if two or more full-lengths are not required. Posts must be installed at a maximum of 6 feet on center when using rail-to-rail connections. Rail-to-rail straight connections are used for longer spans of handrails.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |